Candy Bar: Memorable Mosaic

Today I want to show you a Candy Bar warp made with this beautiful Mosaic Mood Specialty Designer Series Paper (DSP). The paper in the book really does not do the justice. Mosaic tile designs and floral imagery with shiny accents.

This is the look for the candy bar

If you pull the ribbon, you can pull the candy bar out of the sleeves.

Here are the measurements for the paper

6×6 Designer Series Paper-Neutrals:
- 5 1/2 x 5 1/2 (Soft Suede)
Very Vanilla:
- 2 1/2 x 2 1/2 (to cut 2 1/4 circle)
- 2 x 1/2 (for Thank You)
Mosaic Mood Specialty Designer Series Paper
- 1 x 3

Here is how:

Used DSP warp around the candy bar as sleeve. I used Hershey’s 1.55 oz. bar.
Punch out Very Vanilla 2 1/4 circle by using 2 1/4″ circle punch.
Glued the Mosaic Mood DSP and Very Vanilla circle on the sleeve.

Remove the candy bar from the sleeve.
Hold both sides of sleeve together and punched a 1/2″ hold on the Very Vanilla circle as picture below. Make sure punch both holes line together.

Wrapped 18″ ribbon around the candy bar as above picture.
Inserted the candy bar back to the sleeve and pull the ribbon from both holes.

Tied a bow.

There is a sheet of DSP in the pack that has a Hamming bird pattern. I cut the bird out and used the Stampin’ Dimensionals to attach to the Very Vanilla circle.